How do I add addresses to a route without typing them?

With Geo2 you photograph your manifest or parcel labels and its multi-address scanning reads the addresses and adds every stop at once. There is no need to type them one by one.

Is Geo2 good for Amazon Flex?

Yes. Flex drivers use multi-address scanning to load a full block of stops in seconds from their job sheet or labels, then optimize the route in one tap.

Is address scanning free?

Yes. Multi-address scanning is included in the free Geo2 app on iOS and Android.

What is multi-address scanning?

It is a feature that uses your phone camera to read delivery addresses from a manifest or parcel labels and add them all to your route in one batch, ready to optimize.

Multi-Address Scanning

WHY DRIVERS USE IT

Start delivering, not typing

No manual entry

Stop typing addresses one at a time. Photograph the sheet and the whole batch drops in, ready to go.

Straight to the fastest route

Scanned stops feed right into route optimization, so a pile of labels becomes an ordered route in seconds.

Get on the road sooner

Less time setting up in the car park means an earlier start and an earlier finish.

How it works

From labels to route in seconds

Point your camera

Aim at your manifest sheet or a stack of parcel labels.

Geo2 reads them

It recognizes every address on the page and adds each one as a stop.

Optimize and go

Tap once to put them in the fastest order, then start driving.

"On a Flex block I used to spend ten minutes typing addresses in. Now I scan the sheet and I am pulling off before the guy next to me has finished loading."

Shelly N.Amazon Flex Driver

Who is it for?

This is built for high-volume multi-drop drivers, and Amazon Flex drivers especially. When your block starts and you have a job sheet or a pile of labels, scanning gets the entire batch into Geo2 in seconds so you can optimize and go.

It also helps any courier who gets addresses on paper or a printed manifest instead of a tidy digital list.